Multi GradeFilter is used for removal of suspended solids &turbidity from Water & Wastewater. We, at Rushi Ion Exchange offer Series of filters at a low cost, reliable and highly efficientway to filter your water.
Our unique design of Multi Grade Sand filter ensures the maximum utilization of the surface area, lesser pressure drop across the filter bed and effective removal of the impurities even under the conditions of high filtration rate compare to pressure sand filter & dual media filter. Rushi Ion Exchange MGFs are available in diameters from 0.225 Mts. to 4.0 Mts.(vertically) and in length from 3.0 Mts. mm to 11 Mts. (Horizontally) with flow ratesup to 450M3/Hr. these rugged, preengineered, pre-assembled units minimize installation and start-up costs. Whether you require ROfeed process water or filtered water, Rushi Ion Exchange can full fill applications requirement
Raw water is passed through the Multi grade media filter,contains anthracite at a top layer of media followed by fine & Coarse Garnet and quartz sand supported by pebbles and gravels. Multi grades of media and layers provide extra ordinary dirt holding capacity at various level of total media depth and produce unparalleled filter water quality.
During the filtration cycle the largest particles are strained out by the anthracite, coarse and fine sand, Coarse & fine garnet though a combination of adhesion and straining. Since the particles in the water are filtered out at various depths in a multimedia filter, the filter does not clog as quickly as if all of the particles were all caught by the top layer.
|Flow||1M3/Hr. – 450 M3/Hr.|
|Inlet TSS||Up to 50 Mg/L|
|Inlet Turbidity||Up to 40 NTU|
|Filtration Velocity||16 to 25 M3/Hr./M2|
|Diameter (Vertical Vessel)||0.225 Mts. – 4.0 Mts.|
|Length (Horizontal Vessel)||3.00 Mts. – 11.0 Mts.|
|MOC||FRP / Mid Steel / Stainless Steel Coating / lining : Epoxy / FRP / Rubber Lined|
|Filtration Rating||Up to 10 Micron|
|Design Code||ASME / IS|
|Design Pressure||Up to 10 Bar|
|Working Pressure||1.1 to 3.5 Bar|
|Top distribution system||bell mouth|
|Bottom distribution system||Strainer plate or Header & laterals.|